I've repeated the compressed-air-and-cotton-bud cleaning a couple of times, but this is as good as it's going to get I think - and on anything except the blackest of black areas the lines are now unnoticeable. it's almost perfect, with only the faintest of lines still visible. However, looking at the results now, using the same black paper as on the original tests. Running one of those on the underneath of the ADF glass didn't seem to dislodge anything obvious. Fortunately I have a few extra-long and narrow swabs handy. The gap in the housing wasn't big enough to get any kind of cleaning cloth in, and regular cotton buds (Q-Tips) were too short and too thick to reach the glass. A test of the flatbed scan was much better, but the ADF scan was still as noisy as ever - there still seemed to be some kind of dust or dirt on the underneath of the scanning glass used by the ADF. I blew some compressed air in (full disclosure: I actually used a kiddie's paddling pool inflation pump), which resulted in a pleasing amount of dust being blown back at me. By prising those up and jamming a couple of screwdriver bits underneath, I was able to separate the glass from the mechanism just enough to create a gap of maybe a couple of millimetres. The scanner unit itself is almost a separate component, but I couldn't find how to access the screws holding it in place however, there are three plastic clips holding the top half (the glass) to the bottom half (the assembly containing the scanner mechanics). By removing a few screws, I could remove the left-hand side panel of the printer, giving me access to the underneath of the scanner mechanism. I've managed to (almost) solve the problem for myself. Does anyone have any advice on how to resolve or work around the issue - is there any software that will "clean up" these lines automagically? I don't want to replace what is otherwise a perfectly good device just for this relatively trivial problem unfortunately, the issue is starting to become noticeable in my scanned material. Also, the lines on the ADF scan don't correspond to the lines on the flatbed scan - if the problem was dust on the scanhead, wouldn't the lines appear in the same place on both scans? There's no obvious way to tear down the device to get to the underneath of the scanning glass to give that a clean. I've thoroughly cleaned the scanner glass, both the main flatbed and the smaller ADF section, and I've inspected it carefully using a flashlight for any signs of dust or specks of paper - there aren't any, and certainly none the correspond to the position of the vertical lines. The lines appear much worse on the ADF scan. As an example, here's a blank sheet of black poster paper scanned in via the ADF:Īnd here's the same page scanned via the flatbed: However, recently my scanned documents have started to suffer from vertical lines appearing. My HP OfficeJet Pro 8620 has served me well, both as a printer and a document scanner.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |